The 2500 routers don't support full duplex operation. As far as your Sun box, box A appears to be following classful IP rules, automatically assuming that since your first octet is a 61 that your address space is a class A, and therefore your netmask should be 255.0.0.0. I don't know enough about Solaris to tell you how to fix it unfortunately. I'm sure someone on the list does though.
-----Original Message----- From: Kenny Smith [mailto:[EMAIL PROTECTED]] Sent: Tuesday, May 28, 2002 10:17 AM To: [EMAIL PROTECTED] Subject: how to set duplex and speed on 2500 router int ??? [7:45238] Dear all, Question1: May I know how to set the speed and duplex type of the interface ethernet0 of 2500 router. See below.. there is no speed and duplex option unlike IOS switch fasthernet switch. internetRT(config)int e0 internetRT(config-if)#? Interface configuration commands: access-expression Build a bridge boolean access expression arp Set arp type (arpa, probe, snap) or timeout backup Modify dial-backup parameters bandwidth Set bandwidth informational parameter bridge-group Transparent bridging interface parameters cdp CDP interface subcommands cmns OSI CMNS custom-queue-list Assign a custom queue list to an interface delay Specify interface throughput delay description Interface specific description exit Exit from interface configuration mode frame-relay Set frame relay parameters help Description of the interactive help system hold-queue Set hold queue depth ip Interface Internet Protocol config commands ipx Novell interface subcommands keepalive Enable keepalive llc2 LLC2 Interface Subcommands load-interval Specify interval for load calculation for an interface loopback Configure internal loopback on an interface mac-address Manually set interface MAC address mtu Set the interface Maximum Transmission Unit (MTU) netbios Use a defined NETBIOS access list or enable name-caching no Negate a command or set its defaults ntp Configure NTP priority-group Assign a priority group to an interface shutdown Shutdown the selected interface snapshot Configure snapshot support on the interface snmp Modify SNMP interface parameters standby Hot standby interface subcommands transmit-interface Assign a transmit interface to a receive-only interface tx-queue-limit Configure card level transmit queue limit internetRT(config-if)# Question2, When I config my solaris box's (boxA) hme0 as IP 61.9.200.114 netmask 255.255.255.240 broadcast 61.9.200.127. But it keep changed to 61.9.200.114 netmask 255.0.0.0 broadcast 61.255.255.255 after reboot. May I know why? I configure it on another solaris (boxB) but it stays as 61.9.200.114 netmask 255.255.255.240 broadcast 61.9.200.127 after rebooting. Why box A netmask changed? _________________________________________________________________ MSN Photos is the easiest way to share and print your photos: http://photos.msn.com/support/worldwide.aspx Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=45243&t=45243 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
