Hello MADMAN, The config simplely is : LAN interface interface FastEthernet0/1 ip address 172.31.0.1 255.255.0.0 duplex auto speed auto bridge-group 1 Main Interface interface Serial2/0:0 no ip address encapsulation frame-relay ip mroute-cache frame-relay lmi-type ansi bridge-group 1 Suninterface interface Serial2/0:0.1 point-to-point bandwidth 2048 ip address 192.168.1.17 255.255.255.252 ip mroute-cache no arp frame-relay frame-relay interface-dlci 19
Hope that it can help ?. -- Mohannad N. Khuffash Network Administrator Palestine Telecom Tel : 00970-09-2390509 ""MADMAN"" wrote in message [EMAIL PROTECTED]">news:[EMAIL PROTECTED]... > You ae correct in that you configure your bridge group on the physical > and subinterface. You obviously have to configure bridging on some > other interface like your LAN, send a copy of your config. > > dave > > Mohannad Khuffash wrote: > > > > Dear Group, > > I have a problem for implementing the bridging over the Frame Relay > > subinterfaces, Cisco say that you should only enable the bridging over the > > main interface and the subinterface, i have made that but the problem still > > present! Any one have any idea about that. > > Note: When i issue the show bridge group command it show me that every > thing > > is ok , and that the subinterfaces are in forwarding state. > > > > -- > > > > Mohannad N. Khuffash > > Network Administrator > > Palestine Telecom > > Tel : 00970-09-2390509 > -- > David Madland > Sr. Network Engineer > CCIE# 2016 > Qwest Communications Int. Inc. > [EMAIL PROTECTED] > 612-664-3367 > > "Emotion should reflect reason not guide it" Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=45427&t=45336 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
