I was able to use it on my 2600's running 12.2(8), and only tried a handful of commands, which DID work.
Ex: Router-DAL-GateWay(config)#do ? LINE Exec Command Router-DAL-GateWay(config)#do show ? LINE Router-DAL-GateWay(config)#do sh ip int brie Interface IP-Address OK? Method Status Protocol FastEthernet0/0 X.X.X.X YES NVRAM up up Serial0/0 unassigned YES NVRAM up up Serial0/0.1 X.X.X.X YES NVRAM up up Serial0/0.210 192.168.100.1 YES NVRAM up up Serial0/0.310 192.168.100.5 YES NVRAM up up Serial0/0.410 192.168.100.9 YES NVRAM up up Router-DAL-GateWay(config)# Do sh ver, do sh ip ro, do sh run, do sh ip ei top - all yielded expected results... totally awesome for me. It apparently applies to all exec commands, as shown by the following example: Router-DAL-GateWay(config)#do ping 198.6.1.2 Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 198.6.1.2, timeout is 2 seconds: !!!!! Success rate is 100 percent (5/5), round-trip min/avg/max = 12/12/12 ms Router-DAL-GateWay(config)# I've have to get on my 1750s and 2514 to see if it works for them too. -Mark -----Original Message----- From: Moffett, Ryan [mailto:[EMAIL PROTECTED]] Sent: Friday, July 26, 2002 10:47 AM To: [EMAIL PROTECTED] Subject: RE: Check this new command out [7:49717] I have the "do" command in config mode (in c3640-i-mz.122-5d.bin), but the output is only: router(config)#do ? . Version number -----Original Message----- From: Dan Penn [mailto:[EMAIL PROTECTED]] Sent: Friday, July 26, 2002 11:19 AM To: [EMAIL PROTECTED] Subject: RE: Check this new command out [7:49717] Yes, I'm not sure what platforms it does work on, I tried it on 2500's, 2600's and 4500's with no luck Dan -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]] On Behalf Of MADMAN Sent: Friday, July 26, 2002 8:16 AM To: [EMAIL PROTECTED] Subject: Re: Check this new command out [7:49717] Priscilla Oppenheimer wrote: > > MADMAN wrote: > > > > Thought this was pretty cool!! > > > > c7304(config)#do sh ver > > Cool! Can you do stuff other than show version while in config mode?? > Yes it appears you can do most anything, I tried a sh mem, sh config | inclu, sh ip route, they all work. I don't know when/if this will be available in released IOS, I tried it on a 7200 running the latest 12.2.10a, no cigar. Dave -- David Madland Sr. Network Engineer CCIE# 2016 Qwest Communications Int. Inc. [EMAIL PROTECTED] 612-664-3367 "Emotion should reflect reason not guide it" Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=49790&t=49717 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
