Good NM and WIC matrix, answered a q I was about to post http://www.cisco.com/warp/public/471/wics.html
-----Original Message----- From: Priscilla Oppenheimer [mailto:[EMAIL PROTECTED]] Sent: 29 July 2002 22:32 To: [EMAIL PROTECTED] Subject: RE: show process cpu and the interrupt value [7:49954] Some processing supposedly should take place without causing a CPU interrupt. For example, fast switching, if you can believe some descriptions, doesn't interrupt the CPU. Perhaps a high usage consumed by interrupts implies that a lot of traffic isn't being fast switched (or express forwarded). I can't say for sure though. Priscilla bergenpeak wrote: > > When one does a "show process cpu", one is shown the overall > information and then the breakdown per process. > > It's my understanding that the information shown on the summary line, > specifically for the 5 sec information ("30%/24%"), shows the > total > CPU utilization and that which has been consumed handling > interrupts. > In the above snipet, the CPU was operating at 30% utilization > over > the last 5 seconds. A total of 24% of the overall utilization > in the > last 5 seconds was handling interrupts (or at least that's my > understanding) > > Does knowing the interrupt information help one determine anything > about the state of the router or the network? > > Is it better (ie the network/router is healthy) if the interrupt value > is > closer to the overall CPU utilization or closer to 0? > > Thanks Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=50065&t=50065 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]