You can put the bandwidth command on both ends of the circuit and the clockrate on one end of the circuit. It may work in other ways but it looks cleaner this way.
Winston. Winston V. Shaw -----Original Message----- From: Chan, Ricky [mailto:[EMAIL PROTECTED]] Sent: Thursday, August 01, 2002 4:54 PM To: 'Winston Shaw'; [EMAIL PROTECTED] Subject: RE: Routing Question [7:50431] One last question, is it necessary to put the "bandwidth" command and "clock rate" command in all the serial interfaces? So far, I only specified them at router1 both serial interfaces. Router2 serial interfaces have no "bandwidth" command and "clock rate" command. Thanks Ricky -----Original Message----- From: Winston Shaw [mailto:[EMAIL PROTECTED]] Sent: Thursday, August 01, 2002 4:30 PM To: Chan, Ricky; [EMAIL PROTECTED] Subject: RE: Routing Question [7:50431] Please be sure that no auto-summary is configured under the Eigrp processes. Winston -----Original Message----- From: Chan, Ricky [mailto:[EMAIL PROTECTED]] Sent: Thursday, August 01, 2002 3:11 PM To: [EMAIL PROTECTED] Subject: Routing Question [7:50431] Hi all, I have two 2600 series routers setup with 2 serials connections to each other for redundancy. It means when one serial connection failed, the other one still connected. However, I can't get that to work. Below are the router1 and router2 configuration: router1 fa0/0 = ip address 10.10.10.245 255.255.255.0 serial 0/0 = ip address 11.11.11.1 255.255.255.248 serial 0/1 = ip address 12.12.12.1 255.255.255.248 router 2 Thanks Ricky Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=50476&t=50431 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]