soonkyoung kwon wrote: > > dear all > please teach me below command's mean > > map-list atm > ip xxx.xxx.xxx.xxx atm-vc yyy broadcast
Here's the URL to Cisco's documentation: http://www.cisco.com/univercd/home/home.htm Yes, it can be hard to find stuff there. But not too bad. You should know which IOS version you are using to start with. If it's the latest, just go to the link called "Current Cisco IOS Release" under "Hot Items." If it's not the latest release, simply use the pull-down menu titled "Cisco IOS Software" near the top of the page to select your release. >From either of these places, when you are just looking up a single command, sometimes the Master Index is the best place to start. Sometims the Master Index can lead you astray however. In that case, you have to have some idea which document will help you best. In most cases, the Configuration Guides and Command References are most helpful. >From there you have to know that commands dealing with ATM are in the WAN section. Also, see if you can figure out what the command means on your own. What sort of "mapping" might have to happen when dealing with IP and ATM? What is that IP address in the command? Do you recognize it from somewhere else in the config or from some of the output of show commands? Why would you want to use a static map? Are there other solutions (such as Inverse ARP?) Why might you care about broadcasts? Where else do you see map lists? Does Frame Relay use them also? Priscilla Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=51854&t=51852 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]