Mark, Connecting to the firewall from the outside was not allow in the old versions, SSH will be the correct solution...
Juan Blanco -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of Mark W. Odette II Sent: Friday, September 06, 2002 6:25 PM To: [EMAIL PROTECTED] Subject: RE: How to manage the pix 501 remotely via telnet or pdm [7:52831] HUH!?!?! What does ICMP have to do with Telnet or the PDM?? Mindiani- To answer your question, yes there is an alleged way of doing what you're wanting to do. I have not done it myself yet, but there is an example on CCO of how to do such a configuration. Pad Pad Pad http://www.cisco.com/warp/public/110/pdm_vpntun.html For Telnet, as far as I know, there isn't a way to telnet to the PIX from the outside- it's considered a security risk by the firewall group at Cisco, so they don't allow for it. If you want to telnet to the PIX, create a rule on the PIX that allows your specific Internet Host to connect to a telnet device such as a Switch or a Unix box (or even the Telnet Server on Win2K if I dare suggest it), and then hit the PIX from that telnet host. Be sure and configure the PIX with the "telnet 'inside-host-ip' 255.255.255.255 inside" command. Good luck, and let us know how you do! Mark -----Original Message----- From: Dain Deutschman [mailto:[EMAIL PROTECTED]] Sent: Friday, September 06, 2002 4:28 PM To: [EMAIL PROTECTED] Subject: Re: How to manage the pix 501 remotely via telnet or pdm [7:52826] do you have the conduit configured to allow icmp? I think the PIX blocks icmp unless you specifically open a conduit for it. Dain ""mindiani mindiani"" wrote in message [EMAIL PROTECTED]">news:[EMAIL PROTECTED]... > Hi I just installed two PIX 501 with vpn tunnel over the internet for my > client and I would like to allow telnet and pdm from one site to the > other. The tunnels are up and I able to send traffic in both directions > but I cannot telnet into the remote Pix from my PC.I tried the following > command: telnet 172.16.1.2 255.255.255.255 outside This command would > not allow my PC (IP address172.16.1.2) to telnet to the remote site but I > am able to telnet to my servers behind the PIX. i have the same problem > with PDM. > > ------------------------------------------------------------------------ > > Join the worlds largest e-mail service with MSN Hotmail. Click Here Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=52834&t=52834 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]