I am connection a zebra colne (with X.35 cable connecting to a Alcatel-Newbridge 2603 DTU) to Alcatel-Newbridge 3600 bandwidth manager DNIC card, the other end is a Juniper box with E1 interface connecting to 3600 E1 interface. It is like this:
l-------lv.35 l---------l l--------------l l--------l lzebra l-------l2603 l--DNICl3600 box lE1---E1lJuniper l lbox l lDTU l facel l l l l-------l l---------l l--------------l l--------l I make a connection from the DNIC to one E1 timeslot(64K), then make configuration on Juniper's interface for connection.Framing from Juniper E1 to 3600 E1 is G703-nocrc4. I can see the connection is UP. On the zebra box, I set the encapsulation to HDLC-cisco, the same as Juniper encapsulation, but the link is never up! I check the Juniper link status and found it is down (Level 2) while if I made a loop from 3600 timeslot to both sides (I mean to zebra box and Juniper box) I can see on both sides link is up (In Juniper I had to add a no-keepalive configuration). And as I release the loop,again failed. I check the zebra box with show interface command, found CTS is always down, so I made a configuration on 3600 to stop the "end-to-end" signaling and set it to "always on", but the connection on Juniper side is always fail. Is there anything I can do to make the two router boxes connected? By the way, is there anyway I can use to check if there is anything wrong with the layer 2 connection? Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=52841&t=52841 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
