We have a couple of small but critical networks at remote offices we're
wanting to connect to our man office. We have several 2610 and 2620 routers
not being used right now. We'd like to setup a solution at those two sites
that will load balance across two T1's and be redundant.
I don' think true redundancy throughout can be done but here's what I can
come up with:
OSPF on routers A,B,C and D with equal cost paths on routers C and D to
routers A nd B. I've never setup HSRP like this before and I was wondering
if there is anything tricky about the OSPF configuration for routers C and D
to be able to send round robin to routers A and B. I really don't think
there is. Logically, HSRP won't even effect routing decisions leaving the
Primary router in the set until it fails over and then the failover router
should continue sending round robin to routers A and B.
T1 T1
| |
2610(A) 2610(B)
| |
| |
-------------
|
|
2610(C)-HSRP-2610(D)
|
|
Network
If anyone has a better idea or suiggestions with this I'd appreciate your
thoughts.
Thanks,
David Armstrong
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=54255&t=54255
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
