The location of the image should be defined on the hyperterminal. Command "xmodem destination_file_name" tells router to listen to the request from hyperterminal.
Paul ""jghkskgsjk ghsfghsdfhg"" wrote in message news:200210190634.GAA22618@;groupstudy.com... > Hi all, > > > I have a question regarding xmodem in Rom Monitor Mode. I downloaded a > corrupted image on my Cisco 806 Router and then erased the flash and TFTP'd > the new image to it. The install failed and now I'm in Rommon mode. The > TFTPDNLD Command wont work so I'm trying to use xmodem, my question is: when > I upload the new image to the router using the "xmodem -cyrx" command, using > hyperterminal, I know where to put the file on the router, but how do I tell > it where to get the file from on my computer, I found a link on cisco's > website that says : > > The following are the syntax and descriptions for the xmodem console > download command: > > xmodem [-cyrx] destination_file_name > > > > where > > > c > Optional. Performs the download using 16-bit cyclic redundancy check > (CRC-16) error checking to validate packets. Default is 8-bit CRC. > > > > > y > Optional. Sets the router to perform the download using Ymodem protocol. > Default is Xmodem protocol. The protocols differ as follows: > > Xmodem supports a 128-block transfer size. Ymodem supports a 1024-block > transfer size. > > > Ymodem uses (CRC)-16 error checking to validate each packet. Depending on > the device that the software is being downloaded from, this function might > not be supported by Xmodem. > > > > r > Optional. Image is loaded into DRAM for execution. Default is to load the > image into Flash memory. > > x > Optional. Image is loaded into DRAM without being executed. > > destination_file_name > The name of the system image file or the system configuration file. In order > for the router to recognize it, the name of the configuration file must be > router_confg. > > > > > > Follow these steps to run Xmodem: > > > -------------------------------------------------------------------------- ------ > Step 1 Move the image file to the local drive where the Xmodem will execute. > > > Step 2 Enter the xmodem command. > > Where exactly do I put the image file so that xmodem knows where to get it? > Hyperterminal's Program Diectory? > > > Thanx in Advance Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=55939&t=55931 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]