During the transfer of the upgrade file, the switch might not respond to commands for as long as 1 minute. This is normal and correct. If you interrupt the transfer by turning the switch off and on, the firmware could be corrupted. If this happens, follow the procedure described in "Using the Diagnostic Console" in the chapter "Troubleshooting" of the Installation and Configuration guide to restart the firmware.
http://www.cisco.com/univercd/cc/td/doc/product/lan/28201900/1928v9x/19icg9x /19ictrbl.htm#xtocid88938 HTH Bill Creighton CCNP Senior System Engineer Motorola iDEN CNRC Packet Data / MPS -----Original Message----- From: Stephen Neville [mailto:snev@;btopenworld.com] Sent: Wednesday, November 13, 2002 3:11 PM To: [EMAIL PROTECTED] Subject: Re: 1924 Switch [7:57017] I have posted this to the list but havent had one reply surely somone can help me Thanks Stephen ----- Original Message ----- From: "Stephen Neville" To: Sent: Wednesday, November 06, 2002 11:17 PM Subject: 1924 Switch [7:57017] > Hello Group > > Can any one help me get my switch working. Its a 1924 with 2 100tx > but it uses a null modem cable for the console port. I have never had > it working since I have had it, it has a orange status light on the > front but all the port lights are blank. When trying to log on to it > comes up with the > following: > > > > Diagnostic Console - Systems Engineering > > > > Operation firmware version: 0.00 Status: Invalid > > Boot firmware version: 1.08 > > > > > > > > WARNING!!! Operation Firmware is invalid. > > Upgrade firmware to enable switch operation. > > > > [U] Upgrade operation firmware (XMODEM) > > [S] System Debug Interface > > > > Enter Selection: > > > > I have down loaded cat1900A.9.00.04 file from the Cisco website and > tried uploading the image using tera terminal send file option. It > then loads the > file and once finished it says upgrade it comes with the following message: > > > > Erasure completed. Waiting for new image... > > System Upgrade failed. > > > > > > > > > > > > > > Diagnostic Console - Systems Engineering > > > > Operation firmware version: 0.00 Status: Invalid > > Boot firmware version: 1.08 > > > > > > > > WARNING!!! Operation Firmware is invalid. > > Upgrade firmware to enable switch operation. > > > > [U] Upgrade operation firmware (XMODEM) > > [S] System Debug Interface > > > > Enter Selection: > > > > Has any one got any ideas on how to fix this problem. I am sure I > have seen > something like this posted before but at the moment I can not search through > the archives. > > > > Thanks in advance > > > > Steve Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=57392&t=57017 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]