Hi have a problem with a BriS0 (with 2 Voice Port) in a NM-2V. I can only have 2 voice calls in one port and everytime that i need a 3rd call the router send the message " BRI2/1: !!!Check clock source!!! and the the interface is disabled due to lost framming count of 41 in the past 16 msec." here goes an output of the configuration.
version 12.2 service timestamps debug datetime msec localtime show-timezone service timestamps log datetime msec localtime show-timezone service password-encryption ! hostname xpto ! clock summer-time PT recurring last Sun Mar 2:00 last Sun Oct 3:00 ip subnet-zero ! ! no ip domain-lookup ! frame-relay switching isdn switch-type basic-net3 call rsvp-sync ! ! ! ! ! ! ! ! interface FastEthernet0/0 ip address x.x.x.x 255.255.255.0 no ip redirects duplex auto speed auto ! interface Serial0/0 bandwidth 384 no ip address encapsulation frame-relay frame-relay traffic-shaping frame-relay interface-dlci 200 class voz vofr cisco frame-relay route 80 interface Serial0/1 80 ! interface Serial0/0.16 point-to-point bandwidth 144 ip address y.y.y.y 255.255.255.252 frame-relay interface-dlci 16 class dados ! interface BRI0/0 no ip address encapsulation hdlc shutdown isdn switch-type basic-qsig cdapi buffers regular 0 cdapi buffers raw 0 cdapi buffers large 0 ! ! interface BRI1/0 no ip address shutdown isdn switch-type basic-net3 isdn protocol-emulate network isdn layer1-emulate network isdn incoming-voice voice isdn skipsend-idverify ! interface BRI1/1 no ip address isdn switch-type basic-net3 isdn protocol-emulate network isdn layer1-emulate network isdn incoming-voice voice isdn skipsend-idverify ! ip classless no ip http server ! ! ! voice-port 1/0/0 compand-type a-law cptone PT ! voice-port 1/0/1 compand-type a-law cptone PT ! dial-peer cor custom ! ! ! dial-peer voice 2400 pots destination-pattern 4.. direct-inward-dial port 1/0/0 forward-digits all ! dial-peer voice 2401 pots destination-pattern 4.. direct-inward-dial port 1/0/1 forward-digits all ! dial-peer voice 1500 vofr destination-pattern 15.. session target Serial0/0 200 no vad The PBX is a Siemens Hicom 100E If anyone as ideas please write. Thx in advance Best regards Antero Vasconcelos Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=61783&t=61783 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
