Ladies n' Gentlemen, a quick question about the IOS feature set. Does anyone know of a way to configure an async serial port (either a sync/async WIC or the 8/16 port NM) on a 3600 platform to act as a point-to-multipoint FRAD? The application is for SCADA, so a single RS-232 based PC at 1200 bps needs to poll all devices (also RS-232) on the network simultaneously in a classic point-to-multipoint topology. All devices listen to the poll, but only the unit with the correct polled address will respond to the PC in a round-robin fashion. I have 30 of these RTUs, or SCADA devices scattered around all points of a frame-relay network. I would like to pull this off in the 3600 without having to add 2500s to the stack. Mapping an async port directly to a DLCI would be good. My lab only has async on a 2511 (other than AUX), so I can't experiment with it. Any ideas?
Thanks in advance - Ed Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=62797&t=62797 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]