Hello all. I'am stumped on an access-list that i need to create. What i did was i set up two routers using rip and put loopbacks on one of them and advertised them in rip. I then attempted to build an access-list allowing just these networks to pass into the other router. The router with the loopbacks is A the destination is B. so I know this will be a standard access list (direction in) on router B's interface to router A.
The requirements are allow any packet originating from 192.17.77.0 /24 allow any packet originating from 192.17.73.0 /24 allow any packet originating from 192.81.77.0 /24 allow any packet originating from 192.81.73.0 /24 allow any packet originating from 176.17.77.0 /24 allow any packet originating from 176.17.73.0 /24 allow any packet originating from 176.81.77.0 /24 allow any packet originating from 176.81.73.0 /24 Hers what i think i can do with the 182 address i can do permit ip 192.17.73.0 0.64.4.0 because the 64 will increase the second octet to 81 then the 4 in the third bit will increase the network to 77. Is this how i would impliment this filtering policy in just two statements? The same way with the 176 networks? Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=63520&t=63520 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
