Dear Group, I've a problem with EIGRP and hopefully someone can shed some light.
I have a backbone router (bbr1) with two loopback interfaces, (loopback0 172.16.10.100 and loopback1 172.16.11.100), s1 (10.1.1.100/24) which is connected to router p1r1. On bbr1 I have applied the commands: router eigrp 200 network 10.0.0.0 On router p1r1 I have s1 (10.1.1.1/24) connected to bbr1 and I have applied the commands: router eigrp 200 network 192.168.1.0 network 10.0.0.0 When I do "show ip route" on p1r1 I do not see the loopback interfaces from bbr1. According to my book I should have seen in the routing table of p1r1: D EX 172.16.10.0 [170/40537600] via 10.1.1.100, Serial1 D EX 172.16.11.0 [170/40537600] via 10.1.1.100, Serial1 These routes don't show up and I can't ping them either. If I add the command "network 172.16.0.0" on bbr1, the routes appear in the routing table of p1r1 but without "EX". Is it normal to add a network command for your loopback interfaces? Probably there is something else I'm doing wrong. But what?? Thanks, Lesly Verdier Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=65314&t=65314 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
