On Feb 27, 2013, at 4:55 PM, Steve Stockmal <[email protected]> wrote:
> - Add “ip radius source-interface Loopback0” for any switch > addressed with a Loopback address rather than a management address. ISE will > NOT work without this. Steve, Can you be more specific on this? Did you have a TAC case with us that I can refer to? I can't see why the above would be a requirement, all that command does is set the RADIUS packets to be sourced from Loopback 0, you should be able to source your packets from any interface, so long as your network configuration allows that (i.e., routing is in place, no packet filters, etc.). Javier Henderson [email protected]
