With the messages from grub, I am going to assume they are kernel messages. Have U made sure that all of the needed drive and FS stuff in the kernel is there and it is not a module??
DAve b-vol wrote: > Greetings, > > I am doing a clfs build with an amd64 host. I discovered I could not (for > unknown reasons chroot) so I have to boot. I installed and configured all u > to lilo-installation. this fails as shown below:- > > > ############7.13. Lilo-22.8 install > > AS86 version 0.16.10 or later is required > as86 is not present > > LD86 version 0.16.10 or later is required > ld86 is not present > > BCC version 0.16.10 or later is recommended > bcc is not present > You will not be able to make floppy2, diag2.img, or lilo.com > make: *** [test.img] Error 1 > > ######### > > > > > I then decided to use the grub botloader of the host running fedora8. > Unfortunately it fails to boot. > > I get the following message: > > ############ boot message below: > could not open root device /dev//xxx or unknown block (0,0) > please append a correct "root=" > > ############## > > (I have tried various combinations of /dev/sdax /dev/hdax in /etc/grub/conf > (with the appropriate change in $CLFS/etc/fstab without success. > > Help would be appreciated. > > > sincerely > bv > _______________________________________________ > Clfs-support mailing list > [email protected] > http://lists.cross-lfs.org/listinfo.cgi/clfs-support-cross-lfs.org > _______________________________________________ Clfs-support mailing list [email protected] http://lists.cross-lfs.org/listinfo.cgi/clfs-support-cross-lfs.org
