If the remove fails, will the add still succeed? On 3/5/13 11:20 PM, "Bharat Kumar" <bharat.ku...@citrix.com> wrote:
>The changes will be atomic. >before removing any range we need to check if any of the vlans in the >range are in use. The operation will fail if some vlans in the remove >range are in use. >i.e. if E=100-200 (existing) U(used)=101,121,131 >and remove=100-201 we do not remove this range as 101,121, and 131 are >being used. >if the admin wants to remove the reset of the range leaving the used ones >he can say >remove 100-100, 102-120, etc > >I will update this in the FS. > >Bharat. > >On Mar 6, 2013, at 6:11 AM, Chiradeep Vittal ><chiradeep.vit...@citrix.com> wrote: > >> Will the changes be atomic? All or nothing? >> >> Existing range E= 100-200, in use U=101,121,131 >> New request: add=201-301, remove=100-201 >> >> Or >> E = 100-200, U=110-120 >> A = 150-250, R=100-149 >> >> etc >> >> On 1/24/13 10:13 PM, "Bharat Kumar" <bharat.ku...@citrix.com> wrote: >> >>> Thank you Manan for pointing this out i intended to say multiple Vlans >>> not IPs. >>> I corrected it in the FS. >>> >>> Bharat >>> On Jan 25, 2013, at 4:25 AM, Manan Shah <manan.s...@citrix.com> wrote: >>> >>>> Bharat, I reviewed the FS and I have the following question. It states >>>> thatÅ >>>> >>>> Admin can update the vlan range after creation or can add multiple non >>>> contiguous vlan ranges while creating a zone. This can be done by >>>> changing the UpdatephysicalNetwork api. It allows only extending of >>>>the >>>> vlan. we plan to extend the api to update the vlan with multiple ip >>>> Ranges. >>>> >>>> What does it mean by "we plan to extend the API to update the VLAN >>>>with >>>> multiple IP Ranges". Specifically the "Multiple IP Ranges" part. >>>> >>>> Can you clarify? >>>> >>>> >>>> Regards, >>>> Manan Shah >>>> >>>> >>>> >>>> >>>> On 1/4/13 8:49 AM, "Manan Shah" <manan.s...@citrix.com> wrote: >>>> >>>>> Bharat, I have created a JIRA ticket as well as requirements page for >>>>> this >>>>> requirement. Please leverage that. >>>>> >>>>> Regards, >>>>> Manan Shah >>>>> >>>>> >>>>> >>>>> >>>>> On 1/3/13 10:33 PM, "Prasanna Santhanam" <t...@apache.org> wrote: >>>>> >>>>>> On Fri, Jan 04, 2013 at 11:37:28AM +0530, Bharat Kumar wrote: >>>>>>> Hi all, >>>>>>> >>>>>>> In cloudstack we specify the vlan ranges in advanced zone. These >>>>>>> vlans are used while creating the guest networks. Presently we can >>>>>>> add only one continuos vlan range. There is no way to add non >>>>>>> contiguous vlan ranges. >>>>>>> >>>>>>> So we propose to add a feature to support adding multiple vlan >>>>>>> ranges. >>>>>>> >>>>>>> This feature will enable adding non contiguous vlan ranges. >>>>>>> >>>>>> >>>>>> Will it support extending the ranges in non-contiguous increments >>>>>> after the zone has been created? >>>>>> >>>>>> So I start with 100-200 and then later extend my switch and >>>>>>cloudstack >>>>>> to do 300-400, 492 and 50-80 say? >>>>>> >>>>>> -- >>>>>> Prasanna., >>>>> >>>> >>> >> >