Rich Knowles wrote:
Check this out:
http://www.westmarine.com/jabsco--impeller-puller-tools--P011_335_003_502
Rich
On Mar 23, 2014, at 9:49, David Knecht <davidakne...@gmail.com
<mailto:davidakne...@gmail.com>> wrote:
I need to change my impeller and after an earlier discussion and
difficulty removing the present one, I purchased an inexpensive gear
puller to remove it. I tried to use it yesterday and found that
there was very little space between the back of the impeller and the
housing of the water pump, so I could not get the arms of the puller
to grab anything. The arms on the one I bought are quite thick. Do
I need a different tool? Thanks- Dave
David Knecht
Aries
1990 C&C 34+
New London, CT
The Jabsco puller is a fine tool but a bit pricey for a job that you
don't do too often. I got away with using a pair of needle nose vice
grips.
Bill
Caprice 1
_______________________________________________
This List is provided by the C&C Photo Album
http://www.cncphotoalbum.com
CnC-List@cnc-list.com
