An other C&C 33 MKII had added a valve just under the head sink. I did the 
same, way more convenient than go under the setee to close the seacock when the 
boat is on its side. I close it before leaving the dock when i know it will be 
an epic ride.

 

I also maintain (grease) my seacocks and inspect my hose and collars on a 
regular basis, but dont close them anymore. I did it with my first boat and 
forgot to open the water intake a few times...the temp alarm goes on... Good, 
the alarm works.

 

Bruno

C&C 33mk II

Bécassine
 



Date: Mon, 26 May 2014 10:44:21 -0300
To: cnc-list@cnc-list.com
Subject: Re: Stus-List Seacocks
From: cnc-list@cnc-list.com


"I do have to close to seacock to the sink in the head when the wind is up."



Me too, quite a lot of water gets in when the rail is going under if I forget.


Ken H.
C&C 37XL



On 26 May 2014 10:37, coltrek via CnC-List <cnc-list@cnc-list.com> wrote:



Well, I guess I'm a bad seaman too. I have never closed my seacocks either. I 
just make sure that my hoses are good and the connections are sound. I could 
never remember to turn them on when I needed them. I'll take that back. I do 
have to close to seacock to the sink in the head when the wind is up. 



 Bill 
C&C 39




-------- Original message --------
From: dwight via CnC-List 
Date:05/26/2014 5:18 AM (GMT-05:00) 
To: 'Jim Watts' ,cnc-list@cnc-list.com 
Subject: Stus-List Seacocks 



My C&C 35 MKII has 7 Groco bronze seacocks, each one placed in a very hard to 
reach space…since it is well known to be good seamanship to close all seacocks 
when leaving the boat I wonder why the designers did not make them a little 
more easily accessible and with longer handles too…I might be more inclined to 
use them if they were more accessible…however all 7 do move freely open to 
close, the surveyor confirmed that just last week
 




From: CnC-List [mailto:cnc-list-boun...@cnc-list.com] On Behalf Of Jim Watts 
via CnC-List
Sent: May 26, 2014 2:07 AM
To: M Bod; 1 CnC List
Subject: Re: Stus-List First sail
 

Either leave the engine seacock open, or hang the ignition key off the seacock 
handle. Me, I'm useless and we have a Yanmar, so I can start the engine with 
pretty much anything I have in my pocket including lint. I leave the seacock 
open. I know this makes me a bad person and I can live with that. 



Jim Watts
Paradigm Shift
C&C 35 Mk III
Victoria, BC
 

On 25 May 2014 20:13, M Bod via CnC-List <cnc-list@cnc-list.com> wrote:

OK. Boat got off the dock today. After a bunch of engine work, new hoses and 
new fuel tank (all installed by mechanic) everything is supposed to be working 
smoothly.

Well. Getting off the dock was not so smooth. Couldn't sort out why roller 
furler was jamming for a bit.
Finally sorted the issue, started the engine, made sure all looked good 
(exhaust a little louder than I expected, but not bad).

Off we went (had a friend along to assist moving the boat from the marina to a 
nearby cove where it can stay an extra week).

10 min out I see some smoke riding through the companion way. Throttle down. 
Full off engine cowling. Coolant everywhere! Must have a leak.

We turn around to limp back to the dock. I'm looking at the mess with the 
coolant boiling over when I realize (OK remember mechanic warned me) the 
seacock for the engine is CLOSED!!!

Opened the seacock.  Everything cooled off. We had burned off much of our 
coolant - so I poured in a 1/2 litre water bottle. Kept the engine at low rpm 
and made the run to the cove.

Little hitch at the end.  Went to furl the jib but too much sail and not enough 
line on the furling drum. Only managed to pack away 2/3 of the sail. Solved 
that by doing 10 clockwise circles in the bay to wrap the sail around the 
forestay! Dirty, but it worked.
All told we survived. Feel like a royal idiot for forgetting the seacock. Had 
pretty good water shooting out of the muffler after - but I figure I better 
pull the impellor and check/replace it anyway.

I had checked the exhaust when we started - saw splashes. But later realized I 
was looking at the air exhaust hitting the water and causing a little splash.

Still a little shell shocked from the experience but thinking I'll likely 
remember the seacock in the future!!!!!

Mark
_______________________________________________
This List is provided by the C&C Photo Album

Email address:
CnC-List@cnc-list.com
To change your list preferences, including unsubscribing -- go bottom of page 
at:
http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
 
_______________________________________________
This List is provided by the C&C Photo Album

Email address:
CnC-List@cnc-list.com
To change your list preferences, including unsubscribing -- go bottom of page 
at:
http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com




_______________________________________________ This List is provided by the 
C&C Photo Album Email address: CnC-List@cnc-list.com To change your list 
preferences, including unsubscribing -- go bottom of page at: 
http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com                      
              
_______________________________________________
This List is provided by the C&C Photo Album

Email address:
CnC-List@cnc-list.com
To change your list preferences, including unsubscribing -- go bottom of page 
at:
http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com

Reply via email to