I also used ( pure ) vinegar to clean my teck.
For the varnish on the gelcoat, I would use Interlux 299E , was good to remove
antifouling without harm to the gelcoat ( but smallest is a quart )
Sylvain
C&C27MkIII
________________________________
From: Ron Ricci via CnC-List <cnc-list@cnc-list.com>
To: 'Bev Parslow' <bparslo...@yahoo.ca>; cnc-list@cnc-list.com
Sent: Wednesday, August 27, 2014 2:16 PM
Subject: Re: Stus-List varnishing
Bev,
I’ve had excellent results using a spray bottle with 50% clear vinegar & water.
The black stuff comes off with a soft brush. Scrub perpendicular to the grain.
Regards,
Ron
Ronald V. Ricci
S/V Patriot
C&C 37+
Bristol, RI
ron.ri...@1968.usna.com
From:Bev Parslow [mailto:bparslo...@yahoo.ca]
Sent: Wednesday, August 27, 2014 10:46 AM
To: cnc-list@cnc-list.com
Subject: Stus-List varnishing
Ready to start varnishing but how can I get rid of the accumulated black of old
varnish, dirt etc around the teak on the fibre glass. I am trying to get a
clean edge. Can I use paint stripper? Will it hurt the fibre glass?
_______________________________________________
This List is provided by the C&C Photo Album
Email address:
CnC-List@cnc-list.com
To change your list preferences, including unsubscribing -- go bottom of page
at:
http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
_______________________________________________
This List is provided by the C&C Photo Album
Email address:
CnC-List@cnc-list.com
To change your list preferences, including unsubscribing -- go bottom of page
at:
http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com