The bildge pump seems to have stopped working, again! I suspect that it has to do with some of the older wiring becoming corroded and causing a higher resistance. I had this happen before. I'm planning on replacing the Rule 500 with a Whale Gulper 320. I recognize that the capacity is probably on the low side but compared to zero, 320 is a lot and it beats a bucket. The gusher is a single diaphragm pump, can pass debris and has a rated suction lift of 10'. So this means I can mount the pump above the water and have the suction hose run into the deepest and most confined space of the bildge. Hopefully getting the pump out of the water will help prevent corrosion.
Anybody have any thoughts or personal learnings? Josh Muckley S/V Sea Hawk 1989 C&C 37+ Solomons, MD
_______________________________________________ Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
