I was in Maine skiing last week and took a morning off to drive to Hamilton Marine in Searsport to pick p a gallon of Micron 66. This mostly based on Bob Abbott’s experience on Azura which is moored near our boat.
While there I was looking at the active ingredients on Micron 66 vs Micron Extra. The Micron Extra is considerably cheaper and it seemed the copper content not a whole lot less. Does anyone on this list have good experience with the two and what the big difference is between then and what the difference in their intended usage? For good measure perhaps throw in how these two compare to Micron CSC. The old email from Chuck below brought this back to my attention. Thanks Mike Hoyt Persistence Halifax, NS From: Chuck S [mailto:cscheaf...@comcast.net] Sent: Tuesday, March 10, 2015 8:04 PM To: Hoyt, Mike; CNC boat owners, cnc-list Subject: Re: Stus-List bottom paint Used Micron 66 after reading about it on this list. Great paint for salt water. Fast and stays clean compared to VC-Offshore which requires frequent scrubbing. I moved my boat to Chesapeake and now have to change. I'll probably go to Extra and burnish lightly. Chuck Resolute 1990 C&C 34R Broad Creek, Magothy River, Md
_______________________________________________ Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
