On the Buck Algonquin bronze stuffing boxes this works well: http://www.princessauto.com/en/detail/10-in-wide-opening-adjustable-wrench/A-p8306623e
Handles about a 2" nut. Michael Brown Windburn C&C 30-1 Date: Tue, 19 May 2015 12:43:34 -0300 From: "Dr. Mark Bodnar" <drbod...@accesswave.ca> To: C&C list <cnc-list@cnc-list.com> Subject: Stus-List Stuffing box Message-ID: <f81fda73-676b-4b54-9c4a-a640f0216...@accesswave.ca> Content-Type: text/plain; charset="utf-8" First sail/journey of the year. Bedford to Deep Cove in Mahoney Bay - approx 50 nautical miles. Left Bedford Yacht Club and motored out thru Halifax Barbour, around Chebucto Head and through Samboro passage - minimal wind and dead on the nose. Quite pleased with motor overall. I replaced a broken engine mount and the new one (a generic mount I modified to fit) was way better. Engine needs to be re-aligned - hopefully that will decrease vibration even more. Advice appreciated. I've read about it - difficult? On arrival my stuffing box was dripping a fair bit. Little more than 1 drop per second Tried to tighten but couldn't separate the 2 nuts. Sprayed a little PB Blaster - but I'll need a second wrench to counter with rather than spinning whole unit. Any suggestions? Are locking pliers OK? Mark CS 30 Prosecco
_______________________________________________ Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com