Hi, I've purchased soundproofing products from Acoustiguard for use in my house and was happy with them as a supplier. I can't speak specifically to the Barymat product.
I'm also planning to replace my engine compartment insulation as it is disintegrating. I was thinking of Roxul AFB at first and then just saw Acoustiguard has a fibreglass faced mineral fibre board called ML Board that might be worth pricing out. Comes in 1" or 2" thickness and says its uses include engine enclosure linings. The Barymat BTMM-14C is foil faced, 1.25" thick and says its suitable for marine use (dirty, wet or oily). Might be worth getting pricing on as well... Derek McLeod 1983 29-2 Aileron Toronto > On Jan 5, 2016, at 8:47 PM, Dave Syer <syerd...@gmail.com> wrote: > > Thanks Don, (And Tim) > > Will check out the HMP material. I also found something called Barymat BM-1C > at two local industrial suppliers one of whom quoted C$134 for 27sqft. > (54X72) (HMP is C$95 13sqft, not the same stuff though) I have a sample > of the barymat material and it is quite heavy at 1.6lb/sqft. Will compare > its mass to HMP. BM-1C t is .32" thick vs 1" for HMP, but I don't know about > the density. > > http://www.acoustiguard.com/products/acoustic-sheet-roll-materials/barymat-bm-1c.html > > > Anyone ever use this Barymat material? (or similar?) > > Dave > > > > > Message: 1 > Date: Tue, 5 Jan 2016 12:02:28 -0500 > From: Don Newman <donrnew...@gmail.com> > To: cnc-list@cnc-list.com > Subject: Re: Stus-List Engine acoustic insulation, incl. sources in > Canada? > Message-ID: <5b2a703e-d8f7-4f4d-b8b5-d9e2f280d...@gmail.com> > Content-Type: text/plain; charset=us-ascii > > HMP has some good reasonably priced material. > I have left overs if you are near Hamilton. > > Don Newman > 905 547 1750 > > > On Jan 5, 2016, at 11:21 AM, Dave Syer via CnC-List <cnc-list@cnc-list.com> > > wrote: > > > > Hi All, > > > > Have searched the archives and found some great discussion on insulation > > installation practices. Several folks replaced this material in 2014. > > Funny remark on the existing material being "both lily and dusty at the > > same time. Mine is making a mess. > > > > Any particularly good materials to recommend? > > Any suggestions as to sources in Canada? (Toronto specifically - film > > industry gen set people would be ideal...) > > > > Thanks, Dave > > > >
_______________________________________________ Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
