davsclaus opened a new pull request, #3172:
URL: https://github.com/apache/camel-kamelets/pull/3172

   Part of #3170: `aws-kinesis-source` can choose where in the stream it starts 
reading.
   
   Today it always starts at the oldest record the stream keeps 
(`TRIM_HORIZON`), so it reads the whole stream again each time the integration 
starts.
   
   ### New options
   
   | Option | What it does |
   |---|---|
   | `iteratorType` | Where it starts reading: `TRIM_HORIZON` (default, today's 
behaviour), `LATEST`, `AT_SEQUENCE_NUMBER`, `AFTER_SEQUENCE_NUMBER` or 
`AT_TIMESTAMP` |
   | `sequenceNumber` | Required for, and used only by, the two sequence-number 
types |
   | `messageTimestamp` | Required for, and used only by, `AT_TIMESTAMP`. Takes 
an ISO 8601 UTC time such as `2026-11-17T08:00:00Z`, or milliseconds since 1970 
|
   
   ### Descriptions
   
   - The "Good to know" paragraph says the start position applies again on 
every start: it is not remembered across restarts.
   - With `LATEST`, the records written while the integration was stopped are 
not read.
   - The KCL consumer (`useKclConsumers`) keeps its position in DynamoDB and 
ignores `iteratorType`. This comes from reading the component source, not from 
a run.
   - The partial page has a new section, "Where it starts reading".
   
   ### Verification
   
   Tested against the `floci/floci` AWS stand-in. The stream `s3170` held 
`old-1`, `old-2` and `old-3`, and a new record was added after the route 
started.
   
   | Case | Records read |
   |---|---|
   | Options unset | `old-1`, `old-2`, `old-3` (as before) |
   | `LATEST` | Only the new record |
   | `AT_SEQUENCE_NUMBER`, the sequence number of `old-2` | `old-2`, `old-3`, 
the new record |
   | `AFTER_SEQUENCE_NUMBER`, the same sequence number | `old-3`, the new 
record |
   | `AT_TIMESTAMP`, ISO time and then milliseconds | Only the new record, with 
both formats |
   | `AT_SEQUENCE_NUMBER` without `sequenceNumber` | The route does not start: 
"Sequence Number must be specified ..." |
   
   `./mvnw clean install` passed twice, the first time with `-DskipTests`.
   
   _Claude Code on behalf of Claus Ibsen_
   
   🤖 Generated with [Claude Code](https://claude.com/claude-code)
   


-- 
This is an automated message from the Apache Git Service.
To respond to the message, please log on to GitHub and use the
URL above to go to the specific comment.

To unsubscribe, e-mail: [email protected]

For queries about this service, please contact Infrastructure at:
[email protected]

Reply via email to