Hi Andy, thanks for the quick reply.
Andy Green schrieb: > | mmc0: new high speed SDHC card at address b368 > | mmcblk0: mmc0:b368 SD 3931136KiB > | mmcblk0:<6>glamo-mci glamo-mci.0: Error after cmd: 0x8310 > | mmcblk0: error -110 sending read/write command > > This first real error is ETIMEDOUT. It can be a genuine timeout because > your card is a bit slow, but it could also mean communication problems. Not really good timing would probably be a good guess since "Intenso" is a low cost brand around here (germany). > | 2) I can trick it to work doing the following steps: > | - re-set it to this (or possibly any other) value > | >[EMAIL PROTECTED]:~# echo 0 > > /sys/module/glamo_mci/parameters/sd_drive Thanks for your guidance. It's _not_ the sd_drive parameter. It's actually just waiting for about 1-2min. After that the device is readily accessible. (Need to force a re-read of the partition table to mount though.) Anyways I made sure that the data I wrote to the card yesterday is still OK (md5sum) - although it's only around 1MB. I can do more tests tomorrow... Cheers, David _______________________________________________ Openmoko community mailing list community@lists.openmoko.org http://lists.openmoko.org/mailman/listinfo/community