I installed official ASU, but it can't connect to the internet (it connected fine, prior to ASU upgrade).
To establish usb networking I run this script as sudo in Ubuntu: ------------------------ #!/bin/bash iptables -F ifconfig usb0 192.168.0.200 netmask 255.255.255.0 route add 192.168.0.202 usb0 iptables -I INPUT 1 -s 192.168.0.202 -j ACCEPT iptables -I OUTPUT 1 -s 192.168.0.200 -j ACCEPT iptables -A POSTROUTING -t nat -j MASQUERADE -s 192.168.0.0/24 bash -c echo '1 > /proc/sys/net/ipv4/ip_forward' ------------------------ This allows me to ssh into the phone: ssh [EMAIL PROTECTED] But after I log in, I try ping google.com and it says it's a bad address. And if I go to the Installer gui, it says there's a problem with my network. ifconfig shows the following: ------------------------ lo Link encap:Local Loopback inet addr:127.0.0.1 Mask:255.0.0.0 inet6 addr: ::1/128 Scope:Host UP LOOPBACK RUNNING MTU:16436 Metric:1 RX packets:372 errors:0 dropped:0 overruns:0 frame:0 TX packets:372 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:30168 (29.4 KiB) TX bytes:30168 (29.4 KiB) usb0 Link encap:Ethernet HWaddr 26:89:D4:D8:38:1C inet addr:192.168.0.202 Bcast:192.168.0.255 Mask:255.255.255.0 inet6 addr: fe80::2489:d4ff:fed8:381c/64 Scope:Link UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:388 errors:0 dropped:0 overruns:0 frame:0 TX packets:186 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:46744 (45.6 KiB) TX bytes:23237 (22.6 KiB) ------------------------ I see a lot of RX/TX packet errors. Could that be a clue? What am I doing wrong? Dimitri -- View this message in context: http://n2.nabble.com/can%27t-connect-to-internet-after-ASU-upgrade-tp681131p681131.html Sent from the Openmoko Community mailing list archive at Nabble.com. _______________________________________________ Openmoko community mailing list community@lists.openmoko.org http://lists.openmoko.org/mailman/listinfo/community