Does the cable fit completely into your neo? Because my cable doesn't go straight in. Is there a technique to make it fit? Did you have any problems making it fit? Because I think my problem is that my cable doesn't go all the way in.
Lynn On Thu, Sep 11, 2008 at 8:47 AM, andi <[EMAIL PROTECTED]> wrote: > Hypnotize wrote: > > I have tried that to and get the same error messages! :( > > Hi! > > I go the debug board working the first time just a minute ago, but I had > the same errors. > Make sure, you have the flat flexible cable between debug board and > freerunner completely plugged into > the small connector on the freerunner. > This solved my problems ;-) > > andi > > > > On Sun, Sep 7, 2008 at 3:52 AM, Holger Freyther <[EMAIL PROTECTED] > > <mailto:[EMAIL PROTECTED]>> wrote: > > > > On Sunday 07 September 2008 02:22:40 Hypnotize wrote: > > > Hi, > > > > > > I cant get openocd working (with Debug Board v3 and GTA02), I > > just get this > > > error message: > > > > > > $ openocd -f /etc/openocd/openocd.conf > > > Info: openocd.c:84 main(): Open On-Chip Debugger (2007-01-31 > > 12:00 CET) > > > Error: ft2232.c:1351 ft2232_init(): unable to open ftdi device: > > > ftdi_usb_reset failed > > > > sudo openocd? > > > > z. > > > > _______________________________________________ > > Openmoko community mailing list > > community@lists.openmoko.org <mailto:community@lists.openmoko.org> > > http://lists.openmoko.org/mailman/listinfo/community > > > > > > ------------------------------------------------------------------------ > > > > _______________________________________________ > > Openmoko community mailing list > > community@lists.openmoko.org > > http://lists.openmoko.org/mailman/listinfo/community > > > > > _______________________________________________ > Openmoko community mailing list > community@lists.openmoko.org > http://lists.openmoko.org/mailman/listinfo/community >
_______________________________________________ Openmoko community mailing list community@lists.openmoko.org http://lists.openmoko.org/mailman/listinfo/community
