Tuesday 04 of November 2008 17:34:03 Bartłomiej Zimoń napisał(a): > One step closer . this connect script is working well (need tu update always > after change by gui) : > > TIMEOUT 15 > "" "\K\K\K\d+++ATH" > OK-AT-OK ATZ > OK ATE1 > ABORT BUSY > ABORT DELAYED > ABORT "NO ANSWER" > ABORT "NO DIALTONE" > ABORT VOICE > ABORT ERROR > ABORT RINGING > TIMEOUT 60 > OK AT+CFUN=1 > ERROR AT+CPIN="here your pin" # but here after 1st connect i have OK!! and > abort :( > OK AT+COPS > OK AT+CGDCONT=1,"IP","mms" > OK ATD*99# > CONNECT '' > > now ppd connects > but have bad (default) local and remote addresses - is it possible ? > local 10.64.64.64.64 > remote 10.112.112.112 > > ppp0 Link encap:Point-to-Point Protocol > inet addr:10.64.64.64 P-t-P:10.112.112.112 Mask:255.255.255.255 > UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1500 Metric:1 > RX packets:0 errors:0 dropped:0 overruns:0 frame:0 > TX packets:2 errors:0 dropped:297 overruns:0 carrier:0 > collisions:0 txqueuelen:3 > RX bytes:0 (0.0 B) TX bytes:118 (118.0 B) > > # route -n > Kernel IP routing table > Destination Gateway Genmask Flags Metric Ref Use Iface > 10.112.112.112 0.0.0.0 255.255.255.255 UH 0 0 0 ppp0 > 192.168.0.0 0.0.0.0 255.255.255.0 U 0 0 0 usb0 > 0.0.0.0 10.112.112.112 0.0.0.0 UG 0 0 0 ppp0 > > [EMAIL PROTECTED]:~# ping 10.112.112.112 > PING 10.112.112.112 (10.112.112.112): 56 data bytes > > --- 10.112.112.112 ping statistics --- > 7 packets transmitted, 0 packets received, 100% packet loss >
Now even worst after 1-2h power off i have this log after boot : # tail -f /tmp/qtopia-0/qpe-pppd-log-dialup1225707475 timeout set to 15 seconds send (\K\K\K\d+++ATH^M) expect (OK) alarm send (AT^M) expect (OK) alarm Failed Connect script failed _________________ Regards Bartłomiej Zimoń _______________________________________________ Openmoko community mailing list community@lists.openmoko.org http://lists.openmoko.org/mailman/listinfo/community
