Hi there, So far no luck with getting an SSH connection to the FreeRunner.
I've followed the wiki man pages to the letter (http://wiki.openmoko.org/wiki/USB_Networking) as Angus suggests. But this did not change the result. Basically these were the same steps I was already doing (except I need to modprobe g_ehter first). I'm still getting the no route to host error. Disabling my PC wlan connection does not help. Any thoughts? Niels. -- Microsoft gives you windows, Linux gives you the whole house. ---------------------------------------- > From: nyt...@openmoko.org > To: community@lists.openmoko.org > Date: Fri, 7 Aug 2009 08:44:16 -0600 > Subject: Re: Unabel to SSH into Neo Freerunner > > On August 6, 2009 09:07:40 pm c_c wrote: >> Hi, >> I also get the following error :- >> >> usb 2-2: new full speed USB device using ohci_hcd and address 7 >> usb 2-2: configuration #1 chosen from 2 choices >> eth1: register 'cdc_ether' at usb-0000:00:0b.0-2, CDC Ethernet Device, >> 00:1f:11:01:2a:26 >> eth1: no IPv6 routers present >> >> Something to do with ipv6? > > No it means it has been allocated eth1 because it has a static MAC address. So > any setup you do on the PC side needs to be for eth1 and not usb0 > > http://wiki.openmoko.org/wiki/USB_Networking > > Angus > > _______________________________________________ > Openmoko community mailing list > community@lists.openmoko.org > http://lists.openmoko.org/mailman/listinfo/community _________________________________________________________________ Hebben jij en je vrienden leuke foto's van jullie feestje? Maak een groepsalbum en geniet nog extra na. http://www.microsoft.com/belux/nl/windows/windowslive/products/photos.aspx _______________________________________________ Openmoko community mailing list community@lists.openmoko.org http://lists.openmoko.org/mailman/listinfo/community