I have problems with my uSD as well since 2.6.32 See this ticket: http://docs.openmoko.org/trac/ticket/2364 I had no time to test the suggestion in this ticket yet.
Best regards, Jan. On 10/02/2010 08:04 PM, Christian Rüb wrote: > Hi, > > I partitioned my 16GB SDHC (class 2) card, so I had a 512MB ext3 primary > partition as /dev/mmcblk0p1, but Qi would not boot from it. > So I booted my NAND system (older SHR-U, 1.6.29 kernel) which shows me > correct partition with fdisk -l but would not mount it. > > I recreated the filesystem with mkfs.ext3 on freerunner but it still would > not mount it. fsck could not even check the fs: > e2fsck -f -C0 /dev/mmcblk0p1 > e2fsck 1.41.9 (22-Aug-2009) > e2fsck: Superblock invalid, trying backup blocks... > e2fsck: Bad magic number in super-block while trying to open /dev/mmcblk0p1 > > The superblock could not be read or does not describe a correct ext2 > filesystem. If the device is valid and it really contains an ext2 > filesystem (and not swap or ufs or something else), then the superblock > is corrupt, and you might try running e2fsck with an alternate superblock: > e2fsck -b 8193 <device> > > Trying the fsck suggestion to use an alternate superblock did not help either. > > I then created a partition and filesystem over the whole disk, but same > result. No chance to even check the filesystem. > > I also tried to switch back from Qi with glamo 242 to the old one - still no > success. > > In my 2 card readers the card does work though. > > Does anyone of you have any ideas? > > Thanks, > Christian > > _______________________________________________ > Openmoko community mailing list > community@lists.openmoko.org > http://lists.openmoko.org/mailman/listinfo/community _______________________________________________ Openmoko community mailing list community@lists.openmoko.org http://lists.openmoko.org/mailman/listinfo/community