On Tue, 31 Jan 2012 08:07:57 +0100 Radek Polak <pson...@seznam.cz> wrote:
> On Tuesday 31 January 2012 05:39:59 Liz wrote: > > > I tried flashing the NAND with a few other bootloaders. > > What I have now is that pushing the Power key gives me NOR boot. > > First i think you are mixing POWER and AUX button: > > POWER = the circle button near the USB connector > AUX = the rectangular button on the same side as headphones jack > > and you are mixing NOR and NAND: > > NOR = the readonly memory with original uboot > NAND = writable memory with your kernel+rootfs+bootloader > > I think you should first enter NOR boot: hold AUX then press POWER. > You will see uboot menu. > > Now plug USB cable and flash to NAND kernel+rootfs+bootloader: > > dfu-util -a kernel -R -D uImage-v35.bin > dfu-util -a rootfs -R -D qtmoko-debian-v35.ubi > dfu-util -a u-boot -R -D qi-v35.udfu > > Power off the phone and remove your SD card. Now just shortly press > POWER. The phone will blink with LED and vibrate (this is done by qi > bootloader) and should start booting. > > > I can boot an old Om2008 I've got here > > but after that I lost touchscreen input again > > Original QT was working last night - but I don't have a copy of that > > kernel and image any more. > > I think you can forget about booting old kernels and using NOR > bootloader. They are bugged. > > > NOR boot can only boot off SD card if FAT + ext2 > > and so it can't read the debian on ext3 that I made. > > Qi bootloader can boot from SD card with ext3 partition. You just > need to unpack the qtmoko release tarball on SD card. > > > What options do I have to get qtmoko working? > > You can have qtmoko on SD card or on NAND. For bootloader you must > use NAND bootloader which is activated *just with POWER button*. You > can use qi (recommended) or some uboot from gena2x - you have to > search a bit for it. > > Good luck > > Radek Sadly, I don't have Power and Aux buttons confused. I don't have access to NAND from the Power button. Both boot methods start the NOR bootloader. I have loaded those three files into those places and the phone doesn't boot, it says there is a checksum error. I checked the md5sum with sourceforge, and it matches. I've got a SD card with the tarball unpacked onto it, and the phone won't boot that - because I have no Qi bootloader that I can access from the Power key. Last installed was the uboot from gena2x with a default config file, but still this does not work. I need some other ideas, please. _______________________________________________ Openmoko community mailing list community@lists.openmoko.org http://lists.openmoko.org/mailman/listinfo/community