on 8/14/03 1:09 PM, jsoderlund at [EMAIL PROTECTED] wrote: > I just picked up a classic II with 4mb ram would like to max it out @10mb. I > have the ram to put in it but do not know how to get inside the silly thing. > Please advise. > Thanks, jeff > >
Use a long-handled torx driver #15. Available from Sears, Roebuck. Or a long-handled "T" Allen Driver set from (?) Unscrewing the screws in the handle of the Classic II requires the longer shaft. There are two in the handle, and two in the bottom back under the connectors. Leave one screw in the handle. Set the Mac face down on the bed and tap the screw with your palm on the driver handle. The top should split a little. Then press on the SCSI socket with a thumb and the bottom should split. Then remove the back. Remove the socket from the rear of the CRT. Remove the connectors running from the power sweep, the one on its side, remove the connectors from the floppy and hard disk sockets on the motherboard. Slowly slide the motherboard out the back. Jeff -- Compact Macs is sponsored by <http://lowendmac.com/>. Support Low End Mac <http://lowendmac.com/lists/support.html> Compact Macs list info: <http://lowendmac.com/lists/compact.shtml> --> AOL users, remove "mailto:"; Send list messages to: <mailto:[EMAIL PROTECTED]> To unsubscribe, email: <mailto:[EMAIL PROTECTED]> For digest mode, email: <mailto:[EMAIL PROTECTED]> Subscription questions: <mailto:[EMAIL PROTECTED]> Archive:<http://www.mail-archive.com/compact.macs%40mail.maclaunch.com/> --------------------------------------------------------------- >The Think Different Store http://www.ThinkDifferentStore.com ---------------------------------------------------------------
