"John J. Foerch" <[email protected]> writes:
> On Thu, Dec 09, 2010 at 12:09:17PM +0800, zwz wrote:
>>
>> I tried in the same dos cmd again by "set HOME=d:/emacs/home",
>> Conkeror still does not show up.
>>
>> I checked your patch, and I think it should have solved the problem.
>>
>> Is there any tools and procedures to debug the start-up of Conkeror?
>>
>> Best regards,
>> zwz
>
>
> With these kinds of problems, I typically resort to putting 'dumpln'
> calls
> into the source. But I'm not sure if dumpln works normally on Windows or
> whether additional steps are necessary, like passing -console on the
> command line. Try it if you like.
>
> I hope some other Windows users can step up and help figure out what's
> going on. I don't like it when Conkeror is in an "in between" state like
> this.
Yes, I can use dumpln by passing -console on the cmdline, dumping
messages on a new console which closes immediately when errors come up.
Is there any functions to make the console wait for a key press
(like getchar() in C) or sleep for some time?
Anyway, I finally figure out the root of the problem.
#+BEGIN_SRC js
home=home.replace("/", "\\");
#+END_SRC
should be replaced by
#+BEGIN_SRC js
"home = home.replace(/\//g, "\\");"
#+END_SRC
which replace all the occurrences of "/" with "\".
Please apply the patch.
Here is another bug I think:
The wiki says Conkeror loads the ~/.conkerorrc by default.
Now I clear the property "conkeror.rcfile", and find that
"~/.conkerorrc" is not loaded by default (load_rc is not called).
_______________________________________________
Conkeror mailing list
[email protected]
https://www.mozdev.org/mailman/listinfo/conkeror
