installation on PM7600

[張友嘉]

Dear all,   I would like to install mandrake-ppc on my PM7600. However, when I used BootX, it couldn't find CDROM. I tried to load MESH and 53C94 modules, but none of them worked. I browsed the mail-archives and found Phil's BootX. After following the instruction given, I still couldn't make it work. The error message is   [skip] Machine check in kernel mode (regs at c057b9do) caused by (from srr1): unknown values in srr1. [skip] kernel Panic. Reboot in 180 secs.   I also tried the kernels from CD but they didn't work either.   The following is `dmesg |grep scsi`   (scsi0) <Adaptec AHA-294X Ultra SCSI host adapter> found at PCI 0/14/0 (scsi0) Wide Channel, SCSI ID=7, 16/255 SCBs (scsi0) Downloading sequencer code... 422 instructions downloaded scsi0 : Adaptec AHA274x/284x/294x (EISA/VLB/PCI-Fast SCSI) 5.2.1/5.2.0 (scsi0:0:0:0) Synchronous at 40.0 Mbyte/sec, offset 8. (scsi0:0:2:0) Synchronous at 20.0 Mbyte/sec, offset 15. (scsi0:0:3:0) Synchronous at 5.0 Mbyte/sec, offset 15. scsi1 : MESH scsi2 : 53C94 Detected scsi disk sda at scsi0, channel 0, id 0, lun 0 Detected scsi disk sdb at scsi0, channel 0, id 2, lun 0 Detected scsi CD-ROM sr0 at scsi0, channel 0, id 3, lun 0 sr4146: scsi-1 drive   I had a adaptec aha scsi card on scsi0. My harddisk is connected to it. But my CDROM is connected to the interanl SCSI.   Can anybody give any suggestion?   Best regards, Joseph Chang