Yeah, that's what I mean. After mandrake is installed I have no problem
loading it with insmod aha152x aha152x=0x340,9. This works fine so I know the
options are correct. But from DrakX. No matter what I do it refuses to find it.
I have tried typing 'aha152x=0x340,9' also tried just '0x340,9' I tried all
sorts of combinations to put on the aha152x(1-8i) field but it just refuses to
recognize it.
On Thu, 23 Dec 1999, [EMAIL PROTECTED] wrote:
> Daniel Tabuenca <[EMAIL PROTECTED]> writes:
>
> > ...
> > I also ran into a few other problems. When trying to load the aha152x scsi
> > driver I don't know what kind of options it expects. It just doesn't work
> > (didn't work in previous versions of mandrake either.). I know that ot get it
> > to work I need the options for the module. The command I use to load it is
> > 'insmod aha152x aha152x=0x340,9' I tried putting 'aha152x=0x340,9' and tried
> > just 0x340,9 and all sorts of combinations of these parameters but it just
> > refuses to load. Anyone know why this might be?
>
> Have you tested it with DrakX ?
> If not try using Customized/Expert mode and on Setup SCSI step,
> select "Adaptec 152x" and "Specify options" : you will see
> what options are used by the module, then try "0x340,9" in the
> "aha152x(1-8i)" entry field.
> By this way DrakX will load it using insmod with options "aha152x=0x340,9".
>
> > ...
>
> François.
--
============================================================================
"Anyone who is capable of getting themselves elected President should
on no account be allowed to do the job."
--Some wisdom from the Book
============================================================================
