Larry Sword wrote: > > Randy Welch wrote: > > > Larry Sword wrote: > > > > > > Randy Welch wrote: > > > > > > > Found the solution to the Matrox G200/G400 invisible cursor! > > > > > > > > You MUST have sw_cursor set on. You can't see it without it. > > > > > > This is interesting. I have the Matrox G400 32M and don't have the > > > sw_cursor set to on. I don't experience the invisible cursor problem. > > > > > > > Perhaps 32M cards behave differently? I've got a 16M card. > > Sounds like. My card was initially set for 16MB during the install, had to > manually change it to the correct 32Mb. I saw that others have reported > that the setup only installed for half the onboard memory. Could it be that > the cursor problem occurs when the config file list the memory at 8MB or > lower? > After a little checking with the XFDrake stuff it correctly detects the card memory but has it commented out in XF86Config-4. After uncommenting the VideoRam line all is well. I may try re-configuring with XFDrake again and see what it comes up with... -randy > Larry