http://qa.mandrakesoft.com/show_bug.cgi?id=5674
------- Additional Comments From [EMAIL PROTECTED] 2003-17-09 02:37 ------- Packages loaded from cooker at club-internet.fr : drakxtools-9.2-12mdk.i586.rpm drakxtools-http-9.2-12mdk.i586.rpm drakxtools-newt-9.2-12mdk.i586.rpm and harddrake-9.2-11mdk.i586.rpm harddrake-ui-9.2-11mdk.i586.rpm As hardrake requires drakxtools-*-11mdk.i586.rpm, MCC no longer works. harddrake-9.2-11mdk.i586 (drakxtools-newt[== 9.2-11mdk] non satisfait) harddrake-ui-9.2-11mdk.i586 (drakxtools[== 9.2-11mdk] non satisfait) (O/n) o However, I could launch drakconnect # drakconnect modprobe: Can't locate module serial modprobe: Can't locate module serial Please wait while probing serial ports... Arrêt de l'interface eth0 : [ OK ] Arrêt de l'interface eth1 : [ OK ] Arrêt de l'interface loopback : [ OK ] Application des paramètres réseau [ OK ] Démarrage de l'interface loopback : [ OK ] Activation de l'interface eth0 : [ OK ] Activation de l'interface eth1 : [ OK ] First time I left blank the DNS of my provider (free.fr) => no adress resolution : DNS fields are not optional! I launch again drakconnect Success ! All the configuration files seems correct. I wish mcc working before closing the bug-report. -- Configure bugmail: http://qa.mandrakesoft.com/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are on the CC list for the bug, or are watching someone who is. ------- Reminder: ------- assigned_to: [EMAIL PROTECTED] status: NEEDINFO creation_date: description: Fresh install of Mdk9.2rc2 on a new disk. The modem and the link work fine with Mdk9.1 on the other disk. The modem is not detected during the install. The behaviour after install with drakconnect is the same. I have use the assistant in expert and normal mode. /etc/ppp/pppoe.conf : line "USER=" without user. The line "ETH=eth0" is correct [not the bug of 9.1: "ETH=eth0 (using module bcm4400)"] /etc/sysconfig/drakconnect contains 2 lines: # Connection type reminder name= Compare with Mdk9.1: NET_DEVICE=eth0 (using module bcm4400) NET_INTERFACE=ppp0 type=adsl_pppoe
