I always write lilo to the install partition, and use boot
manager as the boot loader. This allows me to switch a
drive, reinstall boot manager if it is the first primary
drive, point to the second drive partition that I want
booted, and reboot.
> [EMAIL PROTECTED] writes:
>
> > Well.... it doesn't work until I unplug the IDE drive
and then re-run lilo. If I
> > then plug the IDE drive back in, and re-run lilo, I
just get the 'Li' and not
> > the
> > Lo again. I have rtfm'ed, to no avail.
>
> the solution to fix this is:
>
> map-drive=0x80
> to=0x81
> map-drive=0x81
> to=0x80
>
> drakx should do it though...
>
>