The same three CD's installed to my Fujitsu C-Series Lifebook with only one hitch, it could not resize my partitions. Installation hung up when I tried. As far as running it came up and ran just fine. I have not seen any problems with it yet.
Basic System Info 1.13 Ghz Intel Pentium i830 chipset (graphics) cdrw/dvd atapi 512 meg ram I have not tried any pcmcia devices yet. Nor USB, but sound works, not sure about the modem (winmodem which has never worked in linux so I stopped trying ;) ) One note, utilities that probe the serial ports complain about the lack of a module for the serial ports, which will never be loaded because there are no serial ports on the laptop. Not a problem. Just a note. David Bolin <[EMAIL PROTECTED]> said: > Installation Problems: > > Other than the previously noted problem with the install disk not being > recognized and having to select cdrom to get it started again I have run into > the following problems: > > Boot Config: > During the boot configuration I was asked to insert Disk 1. Once I did this > it hit the cdrom and then asked me once again to insert the Installation Disk > 1. I then tried each of the disks to make sure that the message was messed > up, but it would except none of the disks. I finally had to cancel. The > Boot configuration went on from that point and I was able to see what was > going into lilo and accept it. (Side note, not sure if it is related to this > error or the next one but once I rebooted I was able to see lilo and select > how I wanted to boot. When linux tried to boot I was rewarded by the kernel > panic message. Unable to mount vfs) > > XConfiguration: > Stuck in a constant loop while offering me the choice between 3.3.6 : 4.2.? : > or 3.3.6 Experimental. None of the options would get me out of the loop. I > would select one and then it would give me an error message (sorry I don't > have it with me right now. I am not on my PC) and then go back to give me the > same options once again. I had to push past and exit install. Which may be > the reason for my failed boot. > > Here is a brief view of my system components > > Asus A7V motherboard > Athlon 1.2 GHZ proc > 384 meg PC133 mem > Promise ATA100 onboard controller > WesterDigital 7200 RPM 40 Gig hard drive running vfat, reiser, swap, reiser > (HDE) > Geforce 4 MX 420 Video card > RealTek 100baseT ethernet adapter > Yamaha CDRW (HDA) > DVDROM (HDC) > ps/2 logitech keyboard > usb logitech optical scroll mouse > > Thanks for your time. > > > > -- > Just when you think you were making progress you realize that you were facing > backwards. > > > > > -- Just when you think you were making progress you realize that you were facing backwards.