Le Mardi 21 Janvier 2003 19:32, Chmouel Boudjnah a écrit : > Pascal Cavy <[EMAIL PROTECTED]> writes: > > Le Mardi 21 Janvier 2003 16:53, Chmouel Boudjnah a écrit : > >> Pascal Cavy <[EMAIL PROTECTED]> writes: > >> > hum, the panic occurs in /etc/rc.sysinit during the mv of the ksyms.? > >> > files so I don't have any oops file available. > >> > >> and do you have any others information message or which process ? > > > > I've got the console output on a tty now. attached. > > look like he doen't like the optimisation of hard drive, what is that > stuff ?
humm could this trigger the kernel panic... I'll try tomorrow to remove this file at the office. I don't have it on my home machine. # cat /etc/sysconfig/harddisks # These options are used to tune the hard drives - # read the hdparm man page for more information # Set this to 1 to enable DMA. This might cause some # data corruption on certain chipset / hard drive # combinations. This is used with the "-d" option USE_DMA=1 # Multiple sector I/O. a feature of most modern IDE hard drives, # permitting the transfer of multiple sectors per I/O interrupt, # rather than the usual one sector per interrupt. When this feature # is enabled, it typically reduces operating system overhead for disk # I/O by 30-50%. On many systems, it also provides increased data # throughput of anywhere from 5% to 50%. Some drives, however (most # notably the WD Caviar series), seem to run slower with multiple mode # enabled. Under rare circumstances, such failures can result in # massive filesystem corruption. USE WITH CAUTION AND BACKUP. # This is the sector count for multiple sector I/O - the "-m" option # MULTIPLE_IO=16 # (E)IDE 32-bit I/O support (to interface card) # # EIDE_32BIT=3 # Enable drive read-lookahead # # LOOKAHEAD=1 # Add extra parameters here if wanted # On reasonably new hardware, you may want to try -X66, -X67 or -X68 # Other flags you might want to experiment with are -u1, -a and -m # See the hdparm manpage (man hdparm) for details and more options. # EXTRA_PARAMS=