On Fri, 2003-02-07 at 04:53, Ryan T. Sammartino wrote:
> Having upgraded to the latest cooker, specifically:
> 
> cups-1.1.18-5mdk
> cups-drivers-1.1-93mdk
> gimpprint-4.2.5-7mdk
> foomatic-filters-3.0-0.beta1.20030203.1mdk
> 
> I observe the following strange behaviour:
> 
> - Having set up my printer using the CUPS web interface, I can click on
>   "Print Test Page", and the Mandrake Linux test page prints just fine.
> - However, if I open up kups and choose to print a test page, only the
>   first couple of lines get printed, then the page is ejected.
> - If I open the test page in kview and press "Print", then I get a page
>   completely covered in black ink.  Not good.
> - If I try to print ANY PostScript file using lpr, or try to print from
>   any program (kword, Mozilla, for example), I get a page full of black
>   ink.  Not good.
> 
> I'm a total loss to figure out why.  I have an HP DeskJet 895Cxi. I'm
> using the HP DeskJet 895C, CUPS+Gimp-Print v4.2.5 driver.  Driver
> settings:
> 
> - Output Mode: Colour.  Changing this makes no difference in behaviour.
> - Resolution: 600x600 DPI.  Changing this make no difference in
>   behaviour.
> - Media Size: Letter, Media Type: Plain
> - STP: Brightness 1.0, Contrast 1.0, Cyan 1.0, Density 1.0, Dither
>   Algorithm: Adaptive Hybrid, Gamma 1.0, Image Type: Solid Colours,
>   Magenta: 1.0, Saturation: 1.0, Yellow: 1.0.
> 
> Changing any of the above does not alter the behaviour observed.
> 
> Prior to upgrading to Cooker (from a 9.0 install), the printer operatoed
> correctly.
> 
> Any suggestions?

For a start, don't use gimp-print. It's not related to your problem, but
HP's ijs stuff is way, way better for HP printers than gimp-print. Use
the hpijs drivers, not gimp-print.
-- 
adamw


Reply via email to