Myles Watson wrote:
-----Original Message-----
From: Tom Sylla [mailto:[EMAIL PROTECTED]
Sent: Wednesday, October 15, 2008 2:04 PM
To: Myles Watson
Cc: Coreboot; ron minnich
Subject: Re: [coreboot] SimNOW VGA int 1a
On Wed, Oct 15, 2008 at 3:56 PM, Myles Watson <[EMAIL PROTECTED]> wrote:
C000:3241 B802B1 mov ax,b102
C000:3244 CD1A int 1a
FFFF:FFFF FF
Yep, "b102" is not a common signature.
I'm looking for the place where the interrupt vector was supposed to
have
been set.
I am confused, your coreboot log shows several int1a before the failure:
int1a vector at 10ffef
dev_find_device: find PCI: 1022:2067
...
int1a vector at 37da2
int1a vector at 37da2
int1a vector at 76682
int1a vector at 76682
int1a vector at 76682
int1a vector at 76682
int1a vector at 76682
int1a vector at 76682
Sorry. I should have sent a new log. It's the same as the old one except
at the end. Once I switched to vm86 instead of x86emu, there is no longer
any output after "Copying VGA ROM Image ..."
Is int1a pci bios calls supported in the emulators?
Marc
--
Marc Jones
Senior Firmware Engineer
(970) 226-9684 Office
mailto:[EMAIL PROTECTED]
http://www.amd.com/embeddedprocessors
--
coreboot mailing list: coreboot@coreboot.org
http://www.coreboot.org/mailman/listinfo/coreboot
