Myles Watson wrote:
OK. I think we're going to get there. It looks like your driver
doesn't
get registered for the device because the PCI IDs don't match.
>From your boot log:
PCI: 00:02.0 subordinate bus PCI Express
PCI: 00:02.0 [8086/5024] enabled
PCI: 00:03.0 subordinate bus PCI Express
PCI: 00:03.0 [8086/5025] enabled
Those IDs match the EP80579 defines in /src/include/device/pci_ids.h,
but
there is no driver defined which uses that ID.
Copy the drivers in /src/northbridge/intel/i3100/pciexp_porta.c, rename
them, and have them use the correct PCI IDs. That should make your
functions get called.
Thanks, I am going to try that as soon I reach the office on Monday. I
will keep you updated.
Thanks.
Hello Gents,
So by following your advices I could get my function called. I had no
time to retrieve the current
sources patch from the development board, but basically I've pretty much
got same settings and
status as the legacy BIOS does.
Unfortunately, I still cannot get a VGA output. I start to get coherent
graphic output as soon Linux
loads the driver, but not before that.
Would you guys have a few additional pointers I could check?
Thank you
Arnaud
*
*
--
coreboot mailing list: [email protected]
http://www.coreboot.org/mailman/listinfo/coreboot
