There's no reason for a board without HyperTransport to compile it in. This patch removes it (saving 1K after compression.)
I would have liked to set HYPERTRANSPORT_PLUGIN_SUPPORT the same way, but couldn't figure out how. I don't think plugin support for HT makes sense... kbuildall tested. Signed-off-by: Myles Watson <myle...@gmail.com> Thanks, Myles
Index: svn/src/Kconfig =================================================================== --- svn.orig/src/Kconfig +++ svn/src/Kconfig @@ -44,14 +44,6 @@ config PCI_BUS_SEGN_BITS bool default n -config HT_CHAIN_UNITID_BASE - hex - default 0x1 - -config HT_CHAIN_END_UNITID_BASE - hex - default 0x20 - config MAINBOARD_PCI_SUBSYSTEM_VENDOR_ID hex default 0 Index: svn/src/devices/Kconfig =================================================================== --- svn.orig/src/devices/Kconfig +++ svn/src/devices/Kconfig @@ -79,7 +79,7 @@ config PCI_64BIT_PREF_MEM config HYPERTRANSPORT_PLUGIN_SUPPORT bool - default y + default n config PCIX_PLUGIN_SUPPORT bool Index: svn/src/devices/Makefile.inc =================================================================== --- svn.orig/src/devices/Makefile.inc +++ svn/src/devices/Makefile.inc @@ -2,7 +2,9 @@ obj-y += device.o obj-y += root_device.o obj-y += device_util.o obj-y += pci_device.o -obj-y += hypertransport.o +ifdef CONFIG_HT_CHAIN_UNITID_BASE + obj-y += hypertransport.o +endif obj-y += pcix_device.o obj-y += pciexp_device.o obj-y += agp_device.o Index: svn/src/mainboard/asus/m2v-mx_se/Kconfig =================================================================== --- svn.orig/src/mainboard/asus/m2v-mx_se/Kconfig +++ svn/src/mainboard/asus/m2v-mx_se/Kconfig @@ -108,7 +108,6 @@ config HAVE_ACPI_TABLES default y depends on BOARD_ASUS_M2V_MX_SE - config LB_CKS_RANGE_END int default 122 @@ -119,3 +118,23 @@ config LB_CKS_LOC default 123 depends on BOARD_ASUS_M2V_MX_SE +config HT_CHAIN_UNITID_BASE + hex + default 0x0 + depends on BOARD_ASUS_M2V_MX_SE + +config SB_HT_CHAIN_UNITID_OFFSET_ONLY + hex + default 0x0 + depends on BOARD_ASUS_M2V_MX_SE + +config SB_HT_CHAIN_ON_BUS0 + hex + default 0x1 + depends on BOARD_ASUS_M2V_MX_SE + +config HT_CHAIN_END_UNITID_BASE + hex + default 0x20 + depends on BOARD_ASUS_M2V_MX_SE +
-- coreboot mailing list: coreboot@coreboot.org http://www.coreboot.org/mailman/listinfo/coreboot
