Make sure that it is 2MB and now 2Mb(it = 256KB). And then pick the right size in coreboot.
Mvh Anders ----- Reply message ----- Fra: "Oliver Schinagl" <[email protected]> Dato: fre., maj 21, 2010 08:36 Emne: [coreboot] Indtast Bcc Indtast Bcc Indtast Bcc Wyse S10 and coreboot Til: <[email protected]> On 05/21/2010 08:28 AM, [email protected] wrote: > You will need the developer package of pciutils, use the name on the > wiki it is in the ubuntu repository. I couldn't find it, well unless it's pciutils and pci-utils-dev :p I'll search more. > > Yes seabios is the best to start of with, download it via git, and > configure it as a payload (se wiki) then make it. All right. > > For coreboot al you need to do is pick s50 as the board, pick the > right Rom size, point to the payload. The romsize defaults to 256k but according to flashrom (And the markings on the chip) it's a 2mb flash unit? Also there's a lot of VGA, VSA and other settings that where very confusing as I read somewhere on the wiki; that the Geode GX2/LX don't support VGA things? And the VSA bit, I found that there is OpenVSA but it's highly experimental? Do I need it at all? > As for network boot you will need an additional tool (look at the wiki). GPXE stuff I belive? Thank you for your time so far! Oliver -- coreboot mailing list: [email protected] http://www.coreboot.org/mailman/listinfo/coreboot
-- coreboot mailing list: [email protected] http://www.coreboot.org/mailman/listinfo/coreboot
