Oliver Schinagl wrote: > Well My electrical engineering knowledge does not reach as far that I would > know where to connect what :) I can read a schematic and solder based on > that, but those pictures from the wiki that I linked, > http://www.coreboot.org/Developer_Manual/Tools/Dual_Flash has a small PCB, > with 2 flash chips on it, but I can't figure out where to connect what.
That's the simple mod with some photos showing the principle at http://stuge.se/m57sli/ A variation to the concept is to have a switch pull down the HOLD# pin to GND. This should also work fine as long as the switch is not toggled while the flash chip is being accessed. > I do think it's a great idea, and maybe it would be an idea to draw the PCB > in kicad/geda or the like, and actually have small batches made. I know > dangerousprototypes.com has loads of small PCB's made for a few bux. I guess whoever made the PCB can publish source and gerbers so that others can order the same board if they want. //Peter -- coreboot mailing list: [email protected] http://www.coreboot.org/mailman/listinfo/coreboot
