Dear Roman,
Am Samstag, den 28.07.2012, 15:15 +0400 schrieb Roman Elshin: > > Hi, I think my problem while using cimx are reset related, looking on > > log of my experiments with sb800 (where more success), I see that first > > initialisation always finished by ...WARM RESET..., and starts after > > it. With cimx it can not start after WARN RESET, (same way as after hard > > reset button), it stops with zero post code, and can begin > > initialization only after power off/on sequence. Can one give some > > direction how to find solution? > > > While playing with bit0,bit1 of SB_MISC_REG84, from my mistake, original > flash chip (it is winbond w25q32) > was programmed by coreboots content. There was used at25df321a (which > are able to boot original bios without such problem) for it before. And > this problem are gone (only chip replacement was enough). were you able to make further progress on your ASRock 880G Pro3 [1]? Currently Sebastian tries to convert the board ASUS M5A88V Evo [2] from the generic coreboot code, which just supports Family 10h processors, to AMD AGESA/CIMx code. Currently he is stuck with SATA problems. So if you have any input/ideas, it would be awesome if you could report back. Thanks, Paul [1] http://www.asrock.com/mb/AMD/880G%20Pro3/ [2] http://www.asus.com/Motherboards/M5A88V_EVO/
signature.asc
Description: This is a digitally signed message part
-- coreboot mailing list: [email protected] http://www.coreboot.org/mailman/listinfo/coreboot
