----[Please read http://ercoupers.com/disclaimer.htm before following any advice in this forum.]----
You can get the plexi drill bits at Home Depot and the like. Even corner hardware stores have these nowadays. If you're good with the grinder you can make your own by sharpening them to a steep angle, say about 30 degrees. One last way to try is to position the bit, then run the drill motor backwards for a few revolutions, scoring the hole pattern completely. Whatever method, go slow and easy (don't push hard) and you'll be okay. Good luck. Al ----- Original Message ----- From: <[EMAIL PROTECTED]> To: <[email protected]> Sent: Thursday, December 07, 2000 4:03 PM Subject: [COUPERS] side window replacement tips > ----[Please read http://ercoupers.com/disclaimer.htm before following any advice in this forum.]---- > > Any tips on cutting and drilling the plexi? I've heard that the trick > for drilling plexi is to use a dull bit to prevent "grabbing" and > cracking. True? I assume you "cut" plexi by scoring it with a > utility knife and then breaking it? > > Thanks! > > Joa > [EMAIL PROTECTED] > > __________________________________________________ > To unsubscribe from this list please send mailto:[EMAIL PROTECTED] > > ___________________________________________________________ > T O P I C A http://www.topica.com/t/17 > Newsletters, Tips and Discussions on Your Favorite Topics > > __________________________________________________ To unsubscribe from this list please send mailto:[EMAIL PROTECTED] ___________________________________________________________ T O P I C A http://www.topica.com/t/17 Newsletters, Tips and Discussions on Your Favorite Topics
<<attachment: winmail.dat>>
